Všechny zprávy

Q: can i plug this camera on the wizar x220s without any soldering?

zeptal se Jay Crow na 2019-01-08 05:09:39

Jinxter78 No, not the same connector, some soldering is needed.

2020-10-03 09:31:06 Ochotný (0)
Předložit
odpovědi (1)

Q: is it inverted sbus

zeptal se Mike Hart na 2019-12-16 04:02:30

Jinxter78 Yes, you connect it to the inverted sbus

2020-09-20 11:57:14 Ochotný (0)
Předložit
odpovědi (2)

Jinxter78 Just remember to keep track of the voltage of the battery. There is no warning in the headset, it just shuts down when the voltage gets too low.

2020-08-14 02:00:06 Ochotný (0)
Předložit
odpovědi (3)

Jinxter78 It helps alot that you can use it without the eyepiece, I always fly without it (tough I preffer to sit since I still wobble a bit, but no nausea.

2020-08-14 01:58:39 Ochotný (0)
Předložit
odpovědi (2)

Q: Are those a regulated shocks? (Can you adjust their hardness?)

zeptal se BG571516441 na 2020-02-26 02:48:07

Jinxter78 Yes, you can adjust the spring tension.

2020-08-14 05:53:35 Ochotný (0)
Předložit
odpovědi (2)

deiity Yes, it has this function. Caddx , Runcam or others camera is ok, just need confirm your camera has OSD Connection Port. Then could use this function.

2020-08-11 01:38:51 Ochotný (0)
Předložit
odpovědi (1)

Q: Have support RSSI on SBUS chanel?

zeptal se pilotnnov na 2019-11-10 09:24:37

Jinxter78 Not default, but it is possible to Flash firmware that supports RSSI.

2020-06-24 03:36:07 Ochotný (1)
Předložit
odpovědi (2)

Q: Any RSSI output?

zeptal se lootshoot na 2019-11-10 02:39:20

Jinxter78 Yes, I run it with the Ibus setting in my Nirvana, but connected to SBUS.

2020-06-24 03:34:09 Ochotný (1)
Předložit
odpovědi (4)

Q: is it compatible with frsky fsi6s

zeptal se BG305117328 na 2020-06-20 02:55:40

Jinxter78 Yes

2020-06-24 03:31:22 Ochotný (0)
Předložit
odpovědi (1)

Q: I'd buy one if it had RSSI.

zeptal se PaulyB na 2019-11-10 09:06:46

Jinxter78 On the Nirvana radio, I can choose both Ibus and SBUS and both seem to work, (using SBUS in betaflight). Not sure what that setting does then. Anyway, to clarify, not only is there no rssi sent to flightcontroller, but also there is no telemetry sent back to the transmitter. This means that there is no way to send rssi from the transmitter to the receiver (I do that normaly, but will update the firmware to get rssi to flight controller). I guess that this is related to be able to get the very long range, but I have not dared to test the range yet (will not do without rssi!).

2020-06-24 03:30:57 Ochotný (0)
Předložit
odpovědi (12)

Q: How do I switch between S-BUS and i-BUS?

zeptal se Zin_007 na 2020-03-15 09:41:25

Jinxter78 Well, setting Ibus in radio settings still workek (however of course connected to flight controller via SBUS). I susoect simply that The receiver is made to Connect to an inverted uart (like SBUS).

2020-05-28 06:54:40 Ochotný (0)
Předložit
odpovědi (3)

Q: What is the IR cut connector for?

zeptal se Jinxter78 na 2019-11-28 05:58:44

Brizaxb sorry not sure for that.

2019-12-04 03:41:11 Ochotný (0)
Předložit
odpovědi (1)