Alle meddelelser

Q: this board has built in bms?

spurgt af BG221154180 på 2021-01-19 05:38:22

brocak No, this has no BMS and the quality of this board is very poor. I ordered one and it just discharged deeply my batteries.

2021-01-19 09:19:34 Nyttig (0)
Indsend
svar (1)

Q: does this fit the FY01 models?

spurgt af BG044101419 på 2021-01-02 05:10:20

brocak Its for 8.4V RC car batteries. It have a resistors in serial with the LEDs for this voltage.

2021-01-03 03:39:55 Nyttig (0)
Indsend
svar (1)

Q: I dont see any temperature sensor for the battery, does it have some?

spurgt af micminarik på 2020-12-14 09:23:09

brocak No,this is a very cheap BMS so it doesnt have any temprerature sensor. If you need a proper one, you have to pay much moore for it !

2020-12-28 01:16:15 Nyttig (0)
Indsend
svar (1)

brocak As its LiFePo4 BMS it is suitable for all LiFePo4 cells also for 32650 ones.

2020-12-28 01:08:46 Nyttig (0)
Indsend
svar (2)

brocak Best is to use an unprotected cells because of low inner resistance and high current output.

2020-12-21 02:22:30 Nyttig (0)
Indsend
svar (2)

Q: Como compramos as baterias ???

spurgt af mvcarvalho4.7 på 2020-01-05 08:38:36

brocak Dont take Meco batteries, they are all srap !

2020-12-21 02:19:29 Nyttig (0)
Indsend
svar (2)

brocak The input connector is very small diameter, some 2mm and the output is 3,5 mm I gues. You need to charge it by CC powersource with the maximum output of 8.4 Volts as they are two in series and two paralel.

2020-12-12 11:43:31 Nyttig (0)
Indsend
svar (1)