All Messages

Zibberman2003 Have you tried booting it up in DFU mode?

2020-08-18 02:43:46 Helpful (0)
Submit
Answers (1)

Zibberman2003 I think it might be limited because of the Real Flight dongle, if you have a wireless dongle for your transmitter try connecting using that while the RF X dongle is also connected as I know Acuerc does a similar thing.

2020-08-18 02:43:06 Helpful (0)
Submit
Answers (1)

Q: Hi, Will these props work/fit Emax TinyHawk 2 Race ?

Asked by matthewcgleeson on 2020-08-18 07:06:52

Zibberman2003 Yes they should work great. I use them on the URUAV UR85HD.

2020-08-18 02:38:54 Helpful (0)
Submit
Answers (3)
Zibberman2003 2020-07-18 04:17:39
I was very sceptical about the quality of video this drone would record in the DVR but I'm so impressed with it I've just ordered another and not just because it's good to have spares but the price was great in this sale. I did find a problem with it on my first test flight where the power kept dipping (not cutting out) and then it just dropped out of the sky and all I could think at the time was, I'm going to need a new main board as this ones faulty. Well after relaxing and gathering my thoughts I remembered that there was a problem last year where some AIO FC boards had an issue where the D16 protocol would cause CPU freeze or terrible range and the only fix was to either switch to D8 or fit different receiver. Well I switched to D8 and it's working perfectly so if your going to buy one yourself just remember to use D8, you won't get full telemetry but you do get the rssi reading in your FPV video. And if you want a good choice for different props I've found the Emax Avan 2 inch quad blade props work perfectly, I did try the 2 inch Avan Rush props from the Tinyhawk 2 Race but they are just a little to big and rub against the ducts. All in all this drone would make a great addition to anyone's growing fleet or like me a great starting point for on-board HD video recording as trying to find the camera you strapped to your drone a after you crash and it's launched into the long grass. So I'm happy to recommend this drone and the fact before writing this review I just bought another says it all, on a scale of 1 to 10 I'd give it 11.
1
Recommendations
Comments (0)

Top reviewers you may like:

Q: What size prop does this use?

Asked by Zibberman2003 on 2020-07-29 04:35:07

Joyfulness 11cm

2020-08-05 01:52:48 Helpful (0)
Submit
Answers (1)

patmaherjfm You really want to be in d8, even connected to betaflight you will notice it goes at snail speed. You can use other receivers, I have a crossfire Rx in mine, power dip dosnt tell us much, it may well be a short failsafe, could be a intermittent motor, does the same corner tend to dtop? That would narrow it down to a motor or esc...

2020-08-03 07:51:33 Helpful (0)
Submit
Answers (1)

Q: Would this work with eachine trashcan?

Asked by supa_poopa on 2019-05-10 02:30:46

Zibberman2003 If the Trashcan has the same U.FL connector it will fit fine, but make sure it's definitely the LHCP one you need because if your FPV setup has an RHCP antenna and you don't match it the video signal will be awful, so double check before you place your order as most FPV gear comes with RHCP antennas.

2020-08-02 01:54:01 Helpful (0)
Submit
Answers (1)

Zibberman2003 The colour means the following, Brown = negative, Red = positive and Orange = signal. The colours all seem to depend on what a manufacturer either prefer to use or it's what was most cost effective at the time.

2020-08-02 01:49:18 Helpful (0)
Submit
Answers (1)

Zibberman2003 It's been a while since I last updated a module but I'm certain it's the inv file you use. But before you do it search banggood for multi protocol module and go to the one that is just a blue pcb with no case and then go to it's details, you should find a few links to some repositories and in one you'll find very detailed instructions on what you need and exactly what to do. That's how I figured it out as I was the same as you now, overloaded with information that was too confusing.

2020-08-02 01:44:30 Helpful (1)
Submit
Answers (3)

Q: Does this come with the black travel case?

Asked by milipu on 2020-07-23 01:50:07

Zibberman2003 Yes it does, a very nice case at that.

2020-07-25 02:05:42 Helpful (1)
Submit
Answers (1)

Q: Will these fit on the Babyhawk R pro 4 inch?

Asked by fizcalpolicy on 2019-08-28 11:23:01

Zibberman2003 They should fit fine but aren't as efficient as the props it comes with.

2020-07-25 02:03:10 Helpful (0)
Submit
Answers (1)

Q: Is this gona work with a Boss AC900 receiver?

Asked by Kimiplayboy on 2019-09-28 02:31:09

Zibberman2003 It should work fine as these new flight controllers are very compatible.

2020-07-25 02:01:52 Helpful (0)
Submit
Answers (1)

Q: Hi, will this reciever bind to a Jumper TS8G v2?

Asked by Hal74 on 2020-07-14 12:55:56

Zibberman2003 Yes, the jumper will bind to nearly every receiver on the market.

2020-07-25 01:56:21 Helpful (0)
Submit
Answers (1)

Q: What are the screws needed specifications ?

Asked by jeanbaptisteburbaud on 2020-07-25 08:40:12

Zibberman2003 The screws, bolts are M2 and 6mm if my memory is right.

2020-07-25 01:55:12 Helpful (0)
Submit
Answers (1)

Q: does a 2 inch propeller fit?

Asked by JPerry04 on 2019-09-16 09:36:47

Zibberman2003 Avan quad blade props fit perfectly, they are the props that come with the Babyhawk r 2 inch.

2020-07-12 05:52:56 Helpful (0)
Submit
Answers (3)