All Messages

woodwaker I just finished upgrading mine to 1 meter side to side. You need 3 pieces the front and back and the laser head piece. You will also need a new belt for the laser motor. I made new cables for the two side motor. You can use one of the side motor cable for the laser motor, but will need a new laser cable. One i got all of the parts put together and cables working it was great..

2018-11-14 02:45:08 Helpful (4)
Submit
Answers (3)

woodwaker I think I have figured out the resistors - R9,R10 and R15 are 3.3K R11,R12 R13 and R14 are 50 Ohm. I'm not sure about R15, but it seems to work. I have no idea what the switches do (S1 to S3) the display changes when they are pushed, but not sure what they do. The instructions seem to be lacking on these points.

woodwaker 2018-10-06 17:11:50
1
Comments (1)

woodwaker I have the same question Could you tell me the values for R9 to R15? they are not labelled on the board

2018-10-17 06:18:54 Helpful (2)
Submit
Answers (1)

Q: Is it possible to extend length of the frame to 1000 x 1000mm?

Asked by tazkindi on 2018-06-20 03:26:32

woodwaker It should be possible, That's what I'm trying to do. Need to find the correct aluminum extrusions 20x20 and 20x40 also need new belting. I have looked at the extrusions on Bangggood, but a comment was made that the profile did not work with the wheels supplied.

2018-07-09 12:01:42 Helpful (0)
Submit
Answers (1)
woodwaker 2018-02-20 20:20:02
0
Recommendations
Comments (0)

Top reviewers you may like:

woodwaker 2018-02-19 14:39:03
0
Recommendations
Comments (0)

Top reviewers you may like: