All Messages

Q: when it's back in EU stock ?

Asked by erik1984 on 2019-03-14 01:32:16

Dave whenthe fat lady sings

2020-05-25 04:45:46 Helpful (0)
Submit
Answers (1)

Q: how to configure to 10hz instead of the default 1hz ?

Asked by erik1984 on 2020-02-02 05:43:11

stigs youneed use U-Center and goto Rate (Rates) in the Configuration view and set the period to 100ms use youtube if you need to see how to do this.

2020-02-07 04:47:15 Helpful (0)
Submit
Answers (1)
erik1984 2019-08-11 16:51:25
1
Recommendations
Comments (0)

Top reviewers you may like:

Q: anyone know how to activate the stobe function ?

Asked by erik1984 on 2019-08-11 01:55:48

mneill59 Bydefault, the strobes are disabled. In the manual, look at the section on Advanced Operation. Go through the procedure of setting your parameters. If you use the ramping operation that comes with the torch by default, then you only have to set 4 parameters. The last one is strobe. Choose option 2 for 1 strobe or option 3 for all of them. Once your parameters have been set, Double click to go into turbo mode, then double click again to go into strobe. Press and hold the button for 1.2 seconds to move on to the next strobe pattern (assuming you chose option 3 above).

2019-08-12 09:02:57 Helpful (0)
Submit
Answers (1)