All Messages

Q: what is the dimensions of the packaging?

Asked by pauloponteprado on 2020-07-05 10:06:42

Laurie It's 800 x 250 x 140mm

2020-07-31 06:53:29 Helpful (0)
Submit
Answers (1)

Q: is it possible to connect a Servo on this receiver?

Asked by danicompracinese on 2018-11-03 07:51:09

Laurie No it uses differential thrust so only has 2-pin motor connectors.

2020-07-17 06:37:41 Helpful (0)
Submit
Answers (5)

Laurie Yes - and the stickers have already been fitted at the factory, as have the pushrods for the rudder and elevator. You need to install the aileron and flap pushrods, and the control horns and clevises for all 6 control surfaces. The 6 servos are pre-installed. The aileron and flap servos have nice long leads, so you can plug each of them into a separate channel on your receiver if you wish, but there are also two Y-connectors provided so you could use a single channel for ailerons and another for flaps. All leads are labelled for easy identification. It's a pretty impressive kit overall. Don't know yet how it flies as I am in COVID lockdown.

2020-07-14 03:10:38 Helpful (0)
Submit
Answers (2)

DonnZee it takes power from the 2s balance plug

2020-07-13 11:49:19 Helpful (0)
Submit
Answers (1)